User`s manual

2-18 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
2
Note
You must supply the cable for this connection package. The JX5 connector
and connector cover is included with the amplifier as part number A02B-
0120-K301. If no E-STOP circuit is required, this connection must be made
with a wire jumper or the amplifier will not enable.
Connector
JX5 Pin 20
supplies +24V DC for the E-STOP circuit. Wire Pin 20 through a normally
closed contact or switch so there is +24V DC to
JX5 Pin 17
when
not
in E-STOP.
GE Fanuc uses
two brands of connectors for the JX5 connector. See figure 2-13 for proper connection to
each type.
CAUTION
Do not apply any external voltage to this connection.
HIROSE 20 Pin PCR Type Connector Pin Configuration
Pins as viewed from
connection
side
for E-Stop
circuit
1
35
7
9
24
6
8
1
0
1
1
13 15
1
7
1
9
12 14
1
6
1
8
2
0
NC Contact
HONDA 20 Pin PCR Type Connector Pin Configuration
Pins as viewed from
connector side
1
024
6
8
13
5
7
9
1
1
12 14
1
6
1
8
13 15
1
7
1
9
2
0
NC Contact
for E-Stop
circuit
Figure 2-13. 20-Pin PCR Connector Pin-Out
6. Connect 24V DC Cable (K12) to the
β
Series Digital Servo Amplifier
A connector for the external 24 VDC supply is included with the amplifier package as a part of
kit A06B-6093-K305 and should be connected to
CX11-4.
The other end of the cable must be
connected to a 24VDC source capable of supplying at least 450 milliamps of current for each
β
Series amplifier. The GE Fanuc IC690PWR024 power supply is recommended.
Do not apply
power at this time
.