Manualshelf

User`s manual

ManualsBrandsBeta ManualsPower Tool1742A
431432433434435436437438439440
Using the Electronic CAM Feature
GFK-1742A Chapter 16 Using the Electronic CAM Feature 16-45
16
We also need to indicate to Axis #1 that we want it to use the Axis #2 commanded position as its
CAM Master source. To do this select, the Axis #1 tab in hardware configuration. Go to the CAM
Master Source data entry field. From the drop-down box, select Cmd Position 2. This will
configure Axis #1 to use the Axis #2 commanded position as it’s CAM master source (Figure 16-
35). While in this tab, change the Home Mode: to Move + and OverTravel Switch to Disabled.
Figure 16-35. CAM Slave Master Source Selection