User`s manual

Using the Electronic CAM Feature
GFK-1742A Chapter 16 Using the Electronic CAM Feature 16-41
16
At this point, we need to add the DSM314 into the rack. To perform this step, select the rack slot
where the DSM314 is to be installed. In our example, we are going to install the DSM314 in slot
number 2. There are several ways to add modules to a rack slot. Two methods to add the module
are presented here (consult the VersaPro documentation for additional details and procedures).
•
You can either (1) double click the desired slot, in this case slot number 2, or (2) right-
click the desired slot (number 2) and then select Add Module.
•
At this point, a dialog box will be generated that allows you to select the module type. In
our case, we want to add a module of type “Motion.” Therefore, we need to select the
“Motion” tab from the dialog box.
•
Select the DSM314 module from the list. The resulting display is shown in Figure 16-31.
Figure 16-31. Hardware Configuration 90-30 rack DSM314 Selection