User`s manual

2-8 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
2
2
.
Connect the Motor Power Cable to the
α
Series Digital Servo
Amplifier.
A. The motor size ordered for your system determines the K4 motor power cable you will use
if you ordered prefabricated cables with your system. The motors in the following table
are grouped to use one of the prefabricated cables available through GE Fanuc. This is not
a complete listing of all
α
Series servomotor power cables, however the ones most
commonly specified are included. A complete listing can be found in the
Servo
specifications Guide
, GFH-001.
Table 2-2. Prefabricated
α
Servo Motor Power Cable (K4) Part Number Examples
Motor
Type
Severe Duty Cable
Catalog Number
Cable Description
Cable
Length
α
3/3000
α
6/3000
IC800CBL061 Elbow MS Connector 14 Meters
α
12/3000
α
22/2000
α
30/1200
IC800CBL062 Elbow MS Connector 14 Meters
α
30/3000
α
40/2000
IC800CBL063 Elbow MS Connector 14 Meters
B. One end of this cable has four wires labeled U, V, W, and GND, which connect to screw
terminals 9-12 on the servo amplifier. Connect these four wires to the terminal strip as
shown in Figure 2-5.
C. Attach the other end of the cable to the motor after first removing the plastic caps
protecting the motor’s connector. Note that this cable is keyed and can only be properly
attached to one of the motor’s connection points.
(Repeat this procedure as needed for any other axes in the system.)
For the most current information on the motor power cables or wiring custom motor power
cables please refer to the latest version of the
α
Series Servo Motor Description Manual
, GFZ-
65142E.