User`s manual

Using the Electronic CAM Feature
GFK-1742A Chapter 16 Using the Electronic CAM Feature 16-25
16
Figure 16-14. Create CAM Program
A “Create New Program” dialog box will now appear that allows you to give the CAM block a
name, a descriptive comment, and select the motion module type. At this time, the CAM feature is
only supported on the DSM314 (release 2.0). Therefore, the default selection for Motion Module
Type should not be changed. (Figure 16-15). The rules for naming a CAM block are:
•
Only the characters A-Z, a-z, 0-9, and _ (underscore symbol) are allowed. Consecutive
underscores are not allowed.
•
The block name must begin with a letter or underscore symbol.
•
A block cannot have the same name as another block that exists in an open folder.
•
A CAM block name may contain up to twenty characters.