User`s manual

16-24 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
16
Figure 16-13. New Folder Wizard page 2
Clicking the finish button will cause VersaPro to create the folder and enter the main program.
Step 2: Create a CAM Block Using the CAM Editor
The CAM editor is integrated into the VersaPro environment. The editor allows you to easily
create, edit, store, and download CAM blocks. To create a CAM block, you must open or create a
new VersaPro folder (see Step 1). Refer to Chapter 15 for information on how to create or open a
folder. Once the VersaPro folder is open, select the File menu selection, then the New
Motion
menu selection, followed by the CAM Program… menu selection. (Figure 16-14)