User`s manual

Using VersaPro with the DSM314
GFK-1742A Chapter 15 Using VersaPro with the DSM314 15-17
15
Printing a Hardcopy of your Local Logic Program
There are two print selections on the File menu: Print and Print Report.
Print:
•
Printing your entire Local Logic file (block):
While the Local Logic Editor is active, click
File on the Menu bar and select Print. The Printer dialog box will display. Make any desired
printer setup changes, then click the OK button.
Figure 15-24. Print Dialog Box
•
Printing just a selected portion of your Local Logic file:
In the Local Logic Editor
window, use your mouse to select the portion you wish to print, click File on the Menu bar,
then select Print. In the Print dialog box (shown above), make sure the Selection radio
button in the Print range section is selected (has a dot in the middle). Click the OK button.
Print Report:
•
To print all Local Logic blocks as part of a report
with the other information in the folder,
click File on the Menu bar and select Print Report. The Print Report dialog box will appear.
Click the Blocks checkbox on the Print Report dialog box. Make sure the All radio button is
selected. (You can also select other items and features for the report such as Table of
Contents, Cross References, Variables, etc.) Click the OK button to begin printing. Motion
program, Local Logic, and Ladder Diagram blocks will be printed as part of this report.
•
To print only selected Local Logic blocks as part of a report
, highlight the desired Local
Logic blocks in the Folder Browser window. Click File on the Menu bar and select Print
Report. Click the Blocks checkbox, then choose the Selected radio button. This limits the
reports to only those blocks that you have highlighted in the Folder Browser window. See
the next figure for an example of this.