User`s manual

Using VersaPro with the DSM314
GFK-1742A Chapter 15 Using VersaPro with the DSM314 15-13
15
Saving your Motion Program
•
When ready to save your motion program/subroutine file to your computer’s hard disk, either
click the Save icon on the tool bar (looks like a floppy diskette), or click File from the Menu
bar and click Save.
Storing your Motion Programs and Subroutines to the PLC
Since the Motion Program/Subroutine file is considered part of the Configuration file group, use
the procedure under the heading “Connecting to and Storing Your Configuration to the PLC,”
documented earlier in this write-up.
Printing a Hardcopy of your Motion Programs and Subroutines
There are two print selections on the File menu: Print and Print Report.
Print:
•
This item describes how to print your entire motion program file (block). While the Motion
Editor is active, click File on the Menu bar and select Print. The Printer dialog box will
display. Make any desired printer setup changes, then click the OK button.
Figure 15-19. Print Dialog Box
•
This item describes how to print just a selected portion of your motion program/subroutine
file. In the Motion Editor window, use your mouse to select the portion you wish to print,
click File on the Menu bar, then select Print. In the Print dialog box (shown above), make
sure the Selection radio button in the Print range section is selected (has a dot in the middle).
Click the OK button.
Print Report:
•
To print all motion program blocks (if you have more than one) as part of a report with the
other information in the folder, click File on the Menu bar and select Print Report. The Print
Report dialog box will appear. Click the Blocks checkbox on the Print Report dialog box.
Make sure the All radio button is selected. (You can also select other items and features for
the report such as Table of Contents, Cross References, Variables, etc.) Click the OK button