User`s manual

2-4 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
2
Section 2: Assembling the Motion Mate DSM314 System
Before discussing specific assembly details, let’s first review these general guidelines:
Always make sure that the connectors lock into the sockets. The connectors are designed to fit
only one way. Do not force them.
Do not overlook the importance of properly grounding the DSM314 system components,
including the DSM314 faceplate shield ground wire
. Grounding information is included in
this section.
All user connections, except for the grounding tab, are located on the front of the DSM314 module.
The grounding tab is located on the bottom of the module. Refer to the figure below and take a few
minutes now to familiarize yourself with these connections.
For instructions about installation of the DSM314 when IEC and other standards must be observed,
see
Installation Requirements for Conformance to Standards
, GFK-1179.
Motion Mate DSM314 Connections
Figure 2-2 provides an overview of the faceplate and labels on the DSM314 module. For
additional information and a complete connection diagram, please refer to chapter 3,
Installing and
Wiring the Motion Mate DSM314
.
Connector C
Servo Axis 3
Status LED’s
STAT
OK
CFG
EN1 - EN4
Connector D
Servo Axis 4
C
OMM
6
-pin RJ-11 connector.
P
rovides RS-232
c
onnection for firmware
u
pgrades
C
onnector A
Servo Axis 1
C
onnector B
Servo Axis 2
G
rounding Tab
Motion Mate DSM314
A
B
C
D
STAT
OK
CFG
EN3
EN4
E
N1
E
N2
C
OMM
Figure 2-2. Face Plate Connections on the Motion Mate DSM314 Motion Control System