User`s manual

15-10 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
15
•
If connecting directly to the PLC programmer port from the COM1 serial port on your
computer, use the DEFAULT settings shown in the figure above.
•
Make sure your serial cable is connected between your computer and the serial port on the
PLC. Then click the Connect button on the Connect dialog box to begin connecting to the
PLC. The message bar at the bottom of the VersaPro screen will display a “Connecting”
message with a horizontal bar graph. Once the connection is made, the Status bar message will
change from Disconnected to Connected.
Stopping the PLC
•
The PLC must be stopped to store configuration files, so click the Stop icon on the Tool bar.
The Stop Execution dialog box will appear.
Figure 15-13. The Stop Execution Dialog Box
•
Click Yes to stop the PLC. The Status bar message at the bottom of the screen will change
from Run Enabled to Stop Disabled.
Store Operation
•
Click the Store to PLC icon on the Tool bar. The Store Folder to PLC dialog box will appear.
Figure 15-14. The Store Folder to PLC Dialog Box
•
Make sure the “Store hardware configuration and motion to PLC” item is checked as shown,
then click the OK button to store to the PLC. Once the store is complete, the message on the
Status bar at the bottom of the screen will change from Not Equal to Equal.