User`s manual

14-6 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
14
Faceplate Output Bit Configuration
The VersaPro programming environment, through Hardware configuration, allows the user to
configure the DSM314 faceplate digital outputs for either Local Logic program control or PLC
program control. To access the Output Bits configuration screen, evoke Hardware configuration
from VersaPro. Once inside Hardware configuration, select the DSM314 module you wish to
configure. Reference GFK-1670 or the VersaPro 1.1 on-line help for the correct menu/toolbar
button sequence to access Hardware configuration. The DSM314 configuration screens contain a
tab (Output Bits). Selecting this tab results in a display similar to the one shown in Figure 14-3.
Figure 14-3. Output Bit Configuration
The following table describes the faceplate outputs that can be controlled from Local Logic or the
PLC.
Table 14-4. Faceplate Output Bit Description
Signal Name Description
OUT1_A Faceplate 24v (SSR) Output Axis 1
OUT3_A Faceplate 5v Output Axis 1
OUT1_B Faceplate 24v (SSR) Output Axis 2
OUT3_B Faceplate 5v Output Axis 2
OUT1_C Faceplate 24v (SSR) Output Axis 3
OUT3_C Faceplate 5v Output Axis 3
OUT1_D Faceplate 24v (SSR) Output Axis 4
OUT3_D Faceplate 5v Output Axis 4