User`s manual

Introduction to Local Logic Programming
GFK-1742A Chapter 10 Introduction to Local Logic Programming 10-35
10
Figure 10-36. Hardware Configuration 90-30 rack DSM314 Selection
This operation will add the DSM314 to the rack and bring up the DSM314 configuration screens.
This will allow the user to customize the DSM314 to their particular application. The reader
should reference chapter 4 for details concerning the DSM314 configuration settings. For the
example, we are going to change the Logic program name and “Local Logic Mode:” These fields
are contained on the “Settings” tab. In the field “Local Logic Mode”, we want to set it to Enabled.
To do this, double click the field, and a dialog box will be displayed. Select Enable and click OK.
In the field “Local Logic Block Name:”, we want to type in the name of our example program. Our
example program is named “LLExample”. Thus, we type “LLExample” into this field.
Note: This method of linking the DSM314 to a Local Logic program was chosen to allow the user
to easily specify multiple DSM314s that all use the same Local Logic program. In our example,
we only have one DSM314. However, if we had multiple DSM314 that all need to run the same
Local Logic program we would simply indicate that in the configuration for the specific DSM314
that needed to execute this program. This allows the programmer to have one Local Logic source
file for multiple DSM314’s. The reader should also note this does not preclude DSM314’s from
executing different programs.
The resulting Hardware Configuration screens will be as shown in Figure 10-37.