User`s manual

Introduction to Local Logic Programming
GFK-1742A Chapter 10 Introduction to Local Logic Programming 10-5
10
Getting Started with Local Logic and Motion Programming
The sections that follow provide information on getting started with the Local Logic Editor and
Motion program editors. The sections concentrate on program usage with an emphasis on program
creation, syntax check, and program download.
Requirements
The Local Logic and Motion Program editors are integrated within the VersaPro programming
environment. Prior to beginning the Local Logic Getting Started section, the user needs to install
VersaPro version 1.1 or later. Please reference the VersaPro documentation for instructions on
how to install this software. The DSM314 feature set also requires 90-30 CPU firmware release
10.0 or higher. Please make sure your CPU Hardware supports this firmware release and is at or
above this revision level.
Getting Started with VersaPro
Once the VersaPro setup process is complete, the integrated Local Logic and Motion Programming
editors are installed onto the computer. The installation process adds the GE Fanuc Software group
to the start toolbar. To access VersaPro, click the Start button, navigate to the VersaPro entry, and
then select VersaPro (Figure 10-2).
Figure 10-2. VersaPro Start Menu