User`s manual

Programmed Motion
GFK-1742A Chapter 7 Programmed Motion 7-7
7
Variables
Motion Programs support a limited set of predefined variables: the parameter data registers and
the CTL bits. In the following table, x represents a decimal value in the specified range. The
value x is interpreted based on its numeric value. Therefore, a given variable may be referenced
several ways. For example, P1 and P001 both refer to Parameter Data Register 1 and will be
accepted by the Motion Editor.
Variable Constraints
Px
0
≤
x
≤
255
CTLx
01
≤
x
≤
32
Separators
Separators are used to separate elements or are added to elements to indicate that they serve a
unique function.
Separator Function
, Separate command parameters
: Identifies a constant as a block number