User`s manual
DSM to PLC Interface
GFK-1742A Chapter 5 Motion Mate DSM314 to PLC Interface 5-13
5
3.12
OUT1_A, B, C, D Output Control / Configurable CTL Bit Source.
Each axis
connector has a 24-vdc solid state relay (SSR) output rated at 125 ma.
The OUT1_A, OUT1_B,
OUT1_C
and
OUT1_D Output Control
%Q bits can control the state of the associated output, but
only if the associated Output Bits configuration is set for PLC Control. Refer to Chapter 4 for
configuration information.
For each axis, the following connector terminals are assigned:
Faceplate
Connector
Pin
Auxiliary TB
IC693ACC336
Terminal
Servo TB
IC693ACC335
Terminal
OUT1 SSR (+) terminal 18 18 8
OUT1 SSR (-) terminal 36 36 16
These %Q bits are also available as sources for configurable CTL bits, independent of the Output
Bits configuration. Refer to Chapter 4 for information on configuring the CTL01-CTL24 bit
sources.
Note
The OUT_1A, B, C, D bits will not control the faceplate outputs unless the
associated Output Bits configuration is set for PLC Control. Refer to
Chapter 4 for configuration information.
3.13
OUT3_A, B, C, D Output Control / Configurable CTL Bit Source.
Each axis
connector has a differential 5-vdc output that is suitable for driving 5v TTL or CMOS loads. The
OUT3_A, OUT3_B, OUT3_C
and
OUT3_D Output Control
%Q bits control the state of the
associated output, but only if the associated Output Bits configuration is set for PLC Control.
Refer to Chapter 4 for configuration information.
For each axis the following connector terminals are assigned:
Faceplate
Connector
Pin
Auxiliary TB
IC693ACC336
Terminal
Servo TB
IC693ACC335
Terminal
OUT3 (+) terminal 14 14 5
OUT3 (-) terminal 32 32 13
Note
The OUT_3A, B, C, D bits will not control the faceplate outputs unless the
associated Output Bits configuration is set for PLC Control. Refer to
Chapter 4 for configuration information.
These %Q bits are also available as sources for configurable CTL bits, independent of the Output
Bits configuration. Refer to Chapter 4 for information on configuring the CTL01-CTL24 bit
sources.