User`s manual

4-32 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
4
Entering Tuning Parameter Numbers and Data in the Advanced Tab Cells
To start, double click the desired cell. For example, if you double clicked the cell on Entry row 1,
in the Axis 1 Par # column, the 1:Axis 1 Par # dialog box would appear, shown below. Enter the
Tuning Parameter Number desired. Remember, DSM314 firmware Release 1.0 only supports
Tuning Parameters 1 and 3. In the example below, a value of 1, representing Tuning Parameter 1
was entered:
Click the OK button, to place a 1 in the Entry row 1, Axis 1 Par # cell. (Shown in Figure 4-2.)
Then, double click in the cell to the right, Entry row 1, Axis 1 Data. The following dialog box will
appear. In this example, the number 2 was entered. Remember, only values between 0 to 3 are
applicable for Tuning Parameter 1 (see Table 4-13).
Click the OK button to place the value 2 in the Entry row 1, Axis 1 Data cell. (Shown in Figure 4-
2.)
Power Consumption Data
This is a display only tab that indicates the power required by the DSM314 module.