User manual

Reflow Controller V3 PRO
Operating Instructions
Page 29 of 39
Command Parameter Definition
trace [0..1] Display internal status messages
trace 1<enter>
Switch on status message display
trace 0<enter>
Switch off status message display
The form and content of status messages may
change in the case of program updates.
tempUnit Setting the temperature unit
tempUnit C<enter> Temperature unit is °C
tempUnit F<enter> Temperature unit is °F
If the temperature unit is changed, the stored tem-
perature profiles are kept, i.e., changing the tempe-
rature unit will not change the temperature status
or soldering result.
bLight [0..10] Setting the display background brightness.
bLight 5<enter>
sets brightness to medium.
The value “0” switches off brightness.
showall Lists all set parameters.
settings [0..4] Selects a parameter set as active. All soldering
operations will be carried out using those
parameters.
settings 3<enter>
All soldering operations will be carried out using
the stored parameter set 3.
doStart Equivalent to START
doStop Equivalent to STOP
doOk Equivalent to OK
doLeft Equivalent to LEFT
doRight Equivalent to RIGHT
doUp Equivalent to UP
doDown Equivalent to DOWN