User manual

Reflow Controller V3 PRO
Operating Instructions
Page 24 of 39
• Pressing OK will activate the menu item and the current brightness value will start to
flash.
• You can change the value as required using the UP and DOWN buttons. The change
to the brightness level takes effect immediately and the display will change to the new
setting.
• Press OK to confirm.
8.5.5 Restoring default values
This menu item is used to reset all controller settings to the factory default, as follows:
• Go to the “Base values” menu (see chapter “Base values”).
• Select the menu item “Factory Default”.
Base Values
Factory Default
• Pressing OK will activate the menu item and a security question will appear on the
display.
Factory Default
OK to Reset
• Pressing OK will reset the values. Pressing UP will deactivate the menu item and the
values will not be reset.
9 Setting parameters via the computer
9.1 Connecting to the computer
The reflow controller has a USB port which enables it to be connected to a PC or Note-
book.
You can also update the reflow controller software via the USB port.
When you attach the USB cable, a new serial interface will be available. Further details
can be found in the section on the USB driver.
You can set controller parameters using this serial interface in the same way as using
the display. Other data such as status and diagnostic information can also be output
and logged for quality assurance purposes.