User manual

Reflow Controller V3 PRO
Operating Instructions
Page 23 of 39
8.5.3 Setting the measurement unit “Temperature”
You can set the measurement unit for the temperature in your reflow controller by se-
lecting one of the following:
C: Temperature unit °C (Celsius)
F: Temperature unit °F (Fahrenheit)
Please note that when you switch temperature units, the change only happens in the
display. Internally, the controller always calculates in °C. This ensures that your tempera-
ture profiles and settings will not be corrupted when you change temperature units.
The temperature measurement unit can be changed as follows:
• Go the “Base values” menu (see chapter “Base values”).
• Select the menu item “TempUnit”. The current value for this setting is shown in the display.
The symbols “F” and “C” stand for Fahrenheit ° F and Celsius ° C, respectively.
• Pressing OK will activate the menu item and the temperature unit symbol will start to
flash.
• The UP and DOWN buttons can be used to change the value as required.
Press OK to confirm.
8.5.4 Setting the background brightness
The display brightness of your reflow controller can be adapted to individual require-
ments. There are 11 levels of brightness, from
0 Display brightness off
to
10 Maximum display brightness
The default value is 5. Please note that if the brightness level is too high, users may
have difficulty reading the display.
Background brightness can be changed as follows:
• Go to the “Base values” menu (see chapter “Base values”).
• Select the menu item “Backlight”. The current value for this setting will be shown in
the display.
Base Values
Backlight 0005