User manual

8 Setting parameters via the display
In general, there are two ways to set parameters in the controller: via the integrated
keyboard or via a connected PC. This chapter explains how to set parameters via the
integrated keyboard.
8.1 Switching the controller to parameterisation mode
The controller is switched to parameterisation mode as follows:
• Press OK and “Setup” will appear in the display
Setup
• Release OK and the display will remain the same.
• Press OK again within 3 seconds and hold for five seconds. A dash will appear in the
top line for every second that has elapsed.
Setup ---
• After the fifth dash, the controller switches to “Setup” mode.
Setup
Ready
You can now switch between menu items using the UP and DOWN buttons. The next
chapter contains details on the menu layout.
Reflow Controller V3 PRO
Operating Instructions
Page 14 of 39