Quick Start Guide

Assistance level
Battery capacity
Information options
Understanding the
BESV Interface
Option 1:
Remove the battery and charge it with the
provided charger.
Option 2:
Charge the battery while it is still in the e-bike with the
provided charger.
Charging the Battery
Understanding
Your BESV E-Bike
Using the
E-Bike’s Functions
The BESV Interface is a convenient way to access
important information about your e-bike.
Refer to the image below for a quick overview of
some of your e-bike’s important parts and features.
100-96%
95-81%
80-61%
40-21%
1-5%
0%
The battery in your BESV e-bike can be charged
in two ways.
Note: Before you ride your e-bike for the first time, charge the
battery for at least five hours, until the battery is fully charged.
Info. Description Unit
Speed Display of current speed
km/hr
(mph)
Trip
distance
Display of current trip distance km (mile)
Trip time Display of current trip time hr:min
Max. speed Maximum speed km/hr (mph)
Avg. speed Average speed km/hr (mph)
Flashing light display Description
Fully charged.
A large amount of energy
is available.
Each bar represents 20%
of the energy being used.
Battery capacity is about 5%
when the battery light flashes.
The battery is empty.
Please charge it immediately.
On-O Switch (Key)
Battery
BESV Interface
Motor
1
2
3
2
1
3
Turning the key to the OFF position
will turn o the e-bike’s power.
Turning on
the E-Bike’s Power
Make sure the battery is installed properly before
turning on the power in your e-bike.
Note: In order to save battery power, the BESV Interface display
backlight will automatically turn o after the e-bike has been
stationary from more than 10 seconds.
Simply insert the key and turn it to
the ON position. The power in your
BESV e-bike is now on.
Level Model Display Description
0 O No assistance, like a normal bike
1 Eco Minimal assistance level
2 Tour Average assistance level
3 Power Maximum assistance level
S Smart Mode Smart mode assistance level
Function Keys
[ ] [ ] [ ] [ ] [ ] [ ]
Information selection
Press [ ]to select information.
Function setting
Press [ ] to enter the function setting page.
Display backlight switch
When the power is turned on, press [ ] once,
and the display backlight will be turned on with
normal brightness. Press [ ] again (a second
time) for more brightness. Press [ ] again
(a third time), and the display backlight will be
turned o.
Assistance mode selection
Press [ ] or [ ] to select assistance levels.
[ ] : increase, [ ] : decrease.
Smart Mode
When the power is turned on, press [ ], and
Smart Mode will be enabled. Press [ ] again,
and Smart Mode will be disabled.
Sensor