Use and Care Manual

ManualsBrandsBestway ManualsAbove Ground Pools14 ft. x 42 in. Deep Power Steel Metal Frame Above Ground Swimming Pool Set with Pump

303021190247

QUESTIONS? PROBLEMS?

MISSING PARTS?

For FAQ, Manuals, Videos Or

Spare Parts, Please Visit

www.bestwaycorp.com/support

TO THE STORE

OWNER’S MANUAL

Visit Bestway YouTube channel

Para la instrucción en español,

visite bestwaycorp.com/support

Summary of content (8 pages)

PAGE 1
TO THE STORE QUESTIONS? PROBLEMS? MISSING PARTS? For FAQ, Manuals, Videos Or Spare Parts, Please Visit www.bestwaycorp.com/support OWNER’S MANUAL Para la instrucción en español, visite bestwaycorp.
PAGE 2
PAGE 3
WARNING smooth out the bottom Put 1in. to 2in. water in the pool to cover the floor. Once pool floor is slightly covered, gently smooth out all wrinkles. Start in the center of the pool and work your way clockwise to the outside.
PAGE 4
90º º 90 After the installation of the pool's steel frame is completed, ensure that the verticals are perpendicular to the ground. If they aren’t, the verticals could be bent or deformed. Do not assemble with pool legs on soft lawn. If you must assemble the pool on a soft surface, timber boards (not included) must be placed under the feet of the vertical support rods for even weight distribution. The timber board must meet two conditions: 1). The thickness is less than 1cm. 2).
PAGE 5
should be equipped with manual means, such as touchpads or switches, to temporarily deactivate the alarm for a single opening of the door from either direction. Such deactivation should last for no more than 15 seconds. The deactivation touchpads or switches should be located at least 54 inches above the threshold of the door. (b) The pool should be equipped with a power safety cover which complies with ASTM F1346-91 listed below.
PAGE 6
Installation usually takes approximately 20 -30 minutes with 2-3 people excluding earthworks and filling. Part descriptions.
PAGE 7
Filling Pool with Water ATTENTION: Do not leave pool unattended while filling with water. 1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse. In times of heavy rainfall you may need to empty some of the water to ensure the level is correct. 2. When filling the pool is completed, check that the water is not collecting on any side to ensure the pool is level. IMPORTANT: If pool is not level, drain water and re-level ground by digging out.