Installation Manual

90024 pg 5
1004 Rev. A
Pull gently down, then out
to release plastic strip
To Remove Duster
When removing the Duster, use the loops
sewn to the fabric to release the plastic strips.
Pull gently down, then straight out to release
the plastic strip from the retainers.
If You Have a New Windjammer on Your Vehicle
Optional Installation
Duster
Pull Flap out and
Over Duster
Windjammer - From
Rear
Step Two - Optional
Locate the flap sewn to the vinyl side of
the Windjammer. Pull the flap out over
the top of the front edge of the Duster.
Step One - Optional
Locate Attaching Snaps from Hardware
Kit supplied with the Windjammer.
Step Three - Optional
Pull up on the front, reinforced edge of the
Duster and mark the locations matching the
three snaps on the Windjammer flap, on the
webbing along the top of the Duster.
Snaps - on underside of flap
Install Studs on Webbing
Reinforced Front Edge of
Duster
Step Four - Optional
At the marked locations, push the sharp end
of a Snap Head Screw through the Duster
from the webbing side, to make a hole. Once
a hole is formed, pull the screw back out of
the hole. Then push the screw through the
hole from the vinyl side so that the snap is
on top of the vinyl. Thread an Acorn Locknut
over the pointed end of the Snap Head
Screw. Snap the Duster and the Windjam-
mer together with the three snaps.
Duster Fabric -
Backing Up
Webbing
Push Snap Head Screw
through to form a hole
Duster Fabric -
Vinyl Up
Acorn Locknut
Snap Head
Screw