Installation Manual

90024 pg 4
1004 Rev. A
Note: The Plastic Protector sewn into the fabric must be located over the Tailgate Retainer Mounts.
Step Six
SECURE REAR CORNERS
Roll the plastic strips, sewn into the rear corners of the Duster into the Corner Retainers. Slide the corner plastic strip toward the
front of the vehicle and make sure that the plastic strip fits up into the retainer so that the collar fits properly.
Plastic Strip
Fabric
Rear Corner
Retainer
Detail of Plastic Strip
Hook and
Loop Strips
Step Seven
S ECURE C OLLARS
Tuck the seat belt assemblies into the rear sport bar collars
and close the rear sport bar collars by pulling firmly on the
fabric and fastening the Hook and Loop Strips to each other.
Tighten the straps on the front of the Duster.
Step Five
S ECURE P LASTIC S TRIPS
Fabric
Side Retainer
Plastic Strip
Plastic Strip
Roll Plastic
Strip into Side
Retainer
Detail of Plastic Strip
Detail of Plastic Protector
Make sure the Plastic Protector
under the fabric covers the end of
Locate the plastic strip sewn to the Duster along each side of the vehicle. Start at one end on each
side and roll the plastic strip into the Side Retainers. Slide strips as far forward of the vehicle.
Plastic
Strip
Tailgate Mount