Installation Manual

80028 pg 4
Rev. B 0204
If You Have a Bestop Duster Rear Deck Cover on Your Vehicle
Duster
Pull Flap out and Over
Duster
Windjammer - From
Rear
Step One
Locate the flap sewn to the rear of the
Windjammer. Pull the flap out over the top
of the front edge of the Duster.
Snaps - on underside
of flap
Install Studs on Webbing
Reinforced Front Edge
Step Two - Optional
Pull up on the front, reinforced edge of the
Duster and mark the locations matching the
three snaps on the Windjammer flap, on the
webbing along the top of the Duster.
Step Three - Optional
At the marked locations, push the sharp end of a
Snap Head Screw through the Duster from the
webbing side, to make a hole. Once a hole is
formed, pull the screw back out of the hole. Then
push the screw through the hole from the vinyl
side so that the snap is on top of the vinyl. Thread
an Acorn Locknut over the pointed end of the
Snap Head Screw.
Fabric -
Backing Up
Webbing
Push Snap Head Screw
through to form a hole
Fabric - Vinyl
Up
Acorn Locknut
Snap Head Screw