Installation Manual

80028 pg 2
Rev. B 0204
Warning: Do not remove the “Z” Channel from
your vehicle once it has been installed. If this
is necessary, make sure the screw holes have
been covered with a sealer.
Step One
Fold the front seats forward and locate the three pieces of "Z" Channel in the
parts kit. Install the three pieces of "Z" Channel on the vertical face of the riser
between the front and rear floors. The 17" piece will be centered in the flat
area in the middle of the vehicle. The two 5" pieces will be installed on the
sides of the curve. The top edge of all channel pieces should be 1/4" down
from the top of the riser. The bottom edge of the channel should be 1 1/2"
down from the top of the riser. Use the holes in the channel pieces as guides
to mark, center punch and drill 1/8" holes. Install the three pieces of channel
using the #8 x 1" Pan Head Screws from the parts kit.
Riser
17" "Z" Channel -
Install with #8 x 1" Pan
Head Screws
5" "Z" Channel - Install
with #8 x 1" Pan
Head Screws
5" "Z" Channel - Install
with #8 x 1" Pan
Head Screws
Front Floor
Rear Floor
Rear Floor
Front Floor
Riser
Windjammer Fabric Qty - 1
"Z" Channel, 5" Qty - 2
"Z" Channel, 17" Qty - 1
Parts List and Hardware Identification
Windjammer Installation
Warning: Check for wiring and fuel lines
before drilling holes in riser.
Rear Floor
1/4"
1-1/2"
1/4"
1-1/2"
Front Floor
Riser
Note: After drilling the holes for the “Z” Channel
in the floor riser, put silicone sealer on the holes
before installing the channel with the screws.
#8 x 1" Pan Head Screw, Qty - 7,
Part Number 295.95
Tools Needed
1/8" Drill Bit and Drill Motor
Phillips Screwdriver
Pencil
#20 Torx Snap Head Screw, Qty - 3,
Part Number 200.49
Acorn Locknut, Qty - 3,
Part Number 293.94