Installation Manual

Tri-Fold Tonneau Installation Instructions
Rev. 1 1109 XXXXX pg. 2
Parts List
Take fully assembled Tri-Fold Tonneau out of box
and unfold.
Remove Tri-Fold Tonneau
from Box
Release Front Clamp
On the driver’s side, reach under the Tonneau and
rotate the front clamp down from the storage position.
Push the top saddle part of the clamp down and
adjust the clamp by rotating it clockwise to loosen or
counter-clockwise to tighten.
Place Tonneau on Bed
Place the Tonneau on the vehicle with the retaining
straps facing up. Align the outside edge of the front
rail with the outside edge of the bed. Center the
Tonneau from side to side.
Saddle
Tonneau Cover,
Qty - 1
Large Hinge, Part
Number 728610.1,
Qty - 2
Small Hinge, Part
Number 728615.1,
Qty - 2
Tie Down Strap,
Part Number
470.95, Qty - 2
Right Clamp, Part
Number 728625,
Qty - 2
#10 x 5/8" Truss
Head Screw, Part
Number 728670,
Qty - 16
Bow Mount, Part
Number 728600,
Qty - 8
Corner, Part
Number 728605.1,
Qty - 2
Left Clamp, Part
Number 728620,
Qty - 2