User manual

BESTip ATA 10L User Manual

Chapter 3: Setup

After connection, follow the easy instructions to setup the

BESTip ATA 10L. You can establish your setup or modify it at

any time by launching the BESTip.

Be sure the BESTip is well-connected and connect the power

adaptor. You must allow the BESTip to finish booting before you

enter the setup mode.

Entering Setup Mode

1. After turned on, the BESTip

will start self-testing, and the

LCD screen will display as shown

right.

2. After system finishing

initializing, the system will start

up DSP.

3. For the first time, the LCD will

display Enter Setup Mode -

Push Down=Yes. Press

button on the front panel to enter

setup mode.

Note: At the BESTip finishes booting, you can always use

or buttons to scroll the menu and press button

to enter the current menu.

BESTip ATA 10L User Manual

1. You can press “DOWN” button at standby status to enter main

menu.

2. Then, you can press “NEXT” or “BACK” button to scroll the menu.

Press “Down” button

to enter main menu.

Press “NEXT” button

to scroll the menu.

Press “BACK” button

to scroll the menu.