User manual

BESTip ATA 10L User Manual
31
Chapter 4: To Make an Internet Call
After having finished the setup in Chapter 3, you are ready to
operate your BESTip. Refer to the illustration below to connect
your BESTip with other devices.
Over Internet or TCP/IP networks, BESTip provides two modes
of voice communication: BESTip-to-BESTip and
BESTip-to-Phone modes. It allows BESTip users to save
greatly on long-distance and international call charges.
Hookup for BESTip ATA 10L
Testing Before Making a Call
After finishing the connection and configuration of your BESTip,
be sure the BESTip is turned on and well connected. You must
allow the BESTip to finish booting before operating.
1. BESTip will start self-testing, and
the LCD screen will display as shown
right.
BESTip ATA 10L User Manual
32
2. Once the system testing finishes,
the screen will display the local time
according to the country code you set
and Blue LED On-Line signal will be
on.
3. You can press to see the
balance and the message “Ready for
Dial” will be shown on the display as
well.
Pick up your telephone handset now, and you can hear a ready
tone that means the basic installation is finished successfully.
Note: The LCD screen will show the current time of your
country according to the country code pre-configured. If the time
displayed is counted from 00:00:00, it means your BESTip is
not successfully registered to the Gatekeeper and your network
connection or configuration might be incorrect. Please refer to
“Chapter 3: Setup” in this manual for network configuration.
If you see the DNS Lookup Fail flashing, it means your BESTip
has not successfully connected to the Internet. Please also refer
to “Chapter 3: Setup” in this manual to configure your network.
To Make a BESTip-to-BESTip Call
If the receiver you call is equipped with an BESTip, you may
enter the IP address directly and talk to the remote BESTip
receiver.
Internet