User manual

BESTip ATA 11L User Manual

Chapter 3: Setup

After connection, follow the easy instructions to setup the

BESTip ATA 11L. You can establish your setup or modify it at

any time by launching the BESTip.

Be sure the BESTip is well connected and switch the power on.

You must allow the BESTip to finish booting before you enter

the setup mode.

Entering Setup Mode

1. After turned on, the BESTip will

start self-testing, and the LCD

screen will display as shown right.

2. After system finishing initializing,

the system will start up DSP.

3. For the first time, the LCD will

display Enter Setup Mode - Push

Down=Yes. Press button

on the front panel to enter setup

mode.

Note: At the BESTip finishes booting, you can always use

or buttons to scroll the menu and press button

to enter the current menu.

BESTip ATA 11L User Manual

1. You can press “DOWN” button at standby status to enter main

menu.

2. Then, you can press “NEXT” or “BACK” button to scroll the menu.

Press “Down” button

to enter main menu.

Press “NEXT” button

to scroll the menu.

Press “BACK” button

to scroll the menu.