User manual

BESTip ATA 10D User Manual
33
2. Once the Internet connection is
built successfully, the display will
show the balance and the message
“Ready for Dial” as well.
3. Pick up the handset and a ready tone can be heard. Please
dial the destination number in the following manner:
For Domestic Long-Distance Calls
[Long-distance code] + [Area code] + [Telephone number] + #
For International Calls
[International code] + [Country code] + [Area code] +
[Telephone number] + #
4. Hold the handset and wait for the connection.
5. Once your receiving party picks up the phone, you can enjoy
the communication.
6. Hang up the phone once the conversation is done. ATA 10D
will remains online. You can make new calls or press to
shut down the Internet connection.
To Receive a BESTip Call
Once your BESTip is connected to the Internet, you may accept
the calls from other BESTip. You cannot receive calls only when
you are in the BESTip Setup mode.
BESTip ATA 10D User Manual
34
Appendix A: Specifications
Interface
Telephone Interface RJ-11 port, 1 x FXS for phone set
Line Interface
RJ-11 port, FXO for built-in 33.6K
modem
Display
16x2 lines LCD display
2 LED Power and ON LINE
Switch button 5 buttons
Voice Codec
Channel Capability 1 Channels
Voice Codecs ITU-T G.723.1 6.3 Kbps
Silence Compression
VAD/CNG
ITU-T G.723 Annex A
Echo Canceller ITU-T G.168-2000 Compliant
Signaling DTMF(TIA464B),
Call progress and user defined
tone pairs
Input/output Gain Programmable
Software/ Hardware
CPU Embedded High Performance
100MHz 16-bit CPU
Memory 8Mb FLASH ROM, 16Mb SDRAM
DSP Chip Set High Quality/Performance DSP for
Voice compression
WAN Interface Built-in 33.6K Analog Modem
Front Control Panel 16 characters x 2 Lines LCD,