User manual

BESTip ATA 10D User Manual
31
2. Once the system testing finishes, it
will go for standby status.
3. Please press to dial ISP to
establish Internet connection.
4. Once Internet connection is
established, you will see Blue LED
On-Line signal will be on. The
display will show the balance and the
message “Ready for Dial” as well.
Pick up your telephone handset now, a ready tone can be heard.
The basic installation is finished successfully. You may make
VoIP calls now.
To Make a BESTip-to-BESTip Call
If the receiver you call is equipped with an BESTip, you may
enter the IP address directly and talk to the remote BESTip
receiver.
1. Make sure that the receiver you want to call is equipped with
an BESTip connected to the Internet.
2. Pick up the handset, and you will hear a ready tone. Dial the
ID No. of the receiving party and ended with a # key.
Note: Every BESTip has a unique eight-digit ID number found
at the bottom of the device.
Internet
BESTip ATA 10D User Manual
32
For example： The ID number of the receiving party is
19990023, so you need to dial 19990023#.
3. Hold the handset, and wait for the connection. You will hear a
ringback tone indicating that your remote BESTip is ringing.
Otherwise, you will hear a busy tone if your remote BESTip user
is on the phone.
4. Once the connection is established, you can enjoy your
communication with your receiving party.
5. Hang up the phone once the conversation is done. ATA 10D
will remains online. You can make new calls or press
to shut down the Internet connection.
To Make a BESTip-to-Phone Call
With Internet Telephony Service Provider (ITSP) service,
BESTip is able to connect to PSTN lines. Having an active ITSP
account, you can call all the world any time with low rates.
Please contact our local distributor to recharge your device
account.
In this mode, the receiver can answer an Internet phone call
with a regular phone.
1. Press button, and ATA
will start connecting to the Internet.
Internet