User`s manual

43
5.2.13.5 Verify HDD
Now press ESC to return to Function#13, and then select part 5 Verify HDD as the following figure
shows. Verify HDD is to verify if the hard disk or any of its partitions can work well.
13-05. Adv Setup
Verify HDD
Press ENT to enter the next figure. Use to confirm Disk or Parti.
Press ENT to verify. After verification LCD will show the results as follows.
Verify HDD
OK
Verify Disk or
Paration? Disk
5.2.13.6 Burn-in
Now press ESC and to enter the following figure. Burn-in is to simulate Erease&Copy, Testing
and Comparing progress many times. The time can be from 1 to 1000. After each cycle of
simulation, the medias on the DVD writers will eject automatically and recede for the next bout of
simulation.
12-06. Adv Setup
Burn-in
Press ENT to enter the next figure. Test is simply a simulation. And there are Compare and
Erase&Copy options can be selected.
Burn-in
Test
Press ENT and use to select the time of simulation such as 1, 2, 3...1000 or Run
Continuous. The figure below shows Run Continuous.
Sel burn-in num:
Run Continuous
Press ENT and use to select the time of trayout such as 10sec,30sec,60sec,90sec ...150sec
or 180sec. The figure below shows 60sec.
Sel Trayout Time
60 sec
Attention
“Erase & Copy” is doing erase & write repeatedly, only Rewriteable
media is supported.
“Compare” is used to compare the source & target if they identical.
Audio CD is not supported due to no ECC.
“Test” is doing copy simulation, DVD+R is not supported.
ARS-2051PC/2074C/2078C Manual