User`s manual
The failed DVD/CD will be held in the DVD burner. The default setting keeps the failed DVD/CD
in the burner and it can be changed. To eject the failed DVD/CD, you have to press the eject key
on the DVD burner.
Do not press any key during the copying process. Abrupt interruption may damage the system
and the DVD/CD.
3.3.2 Without an Internal Hard Drive
When a 3.5-inch SATA hard drive is not connected to the ARS-2051PC/2074C/2078C, please
follow the operational procedures below:
14
Insert a source DVD/CD into the DVD burner.
Switch the first function, “Copy” by pressing ▲ or ▼. Insert a blank DVD/CD into the DVD burner
and press ENT to start copying.
Upon completion of data copying, the successfully duplicated DVD/CD will be ejected
automatically. The default setting is automatic ejection and it can be changed.
The failed DVD/CD will be held in the DVD burner. The default setting keeps the failed DVD/CD
in the burner and it can be changed. To eject the failed DVD/CD, you have to press the eject key
on the DVD burner.
Before installing any hardware, please check the SATA cable first.
Connect to
ARS-2051PC/2074C/2078C
SATA port
Connect to SATA port of
SATA HDD/DVD-ROM/DVD writer
30cm
Connect to
ARS-2078C SATA port
Connect to SATA port of
SATA HDD/DVD-ROM/DVD writer
70cm
Please check that the SATA cable is properly connected before installing the hardware.
The SATA HDD can be connected directly to the SATA port on the ARS-2051PC/2074C/2078C
board via the SATA cable.
Connect to
ARS-2074C SATA port
Connect to SATA port of
SATA HDD/DVD-ROM/DVD writer
50cm
Attention: When connecting SATA cable to the port, plug it in till you hear a click. To unplug the
SATA cable, press the latch and remove it. (Do not force to remove the cable.)
ARS-2051PC/2074C/2078C Manual