Specifications

36
USB_WAKE_UP
USB_DETACH
Port_Imbedance
USB_DPUSB_DN
USB_PULL_UP
10ms max
10ms max
10ms max
No max
Disconnected
Figure 12: USB_DETACH and USB_WAKE_UP Signal
6.2.6 USB Driver
A USB Bluetooth device driver is required to provide a software interface between WT32
and Bluetooth software running on the host computer. Suitable drivers are available from
www.bluegiga.com/techforum/.
6.2.7 USB 1.1 Compliance
WT32 is qualified to the USB specification v1.1, details of which are available from
http://www.usb.org. The specification contains valuable information on aspects such as PCB
track impedance, supply inrush current and product labeling.
Although WT32 meets the USB specification, Bluegiga Technologies cannot guarantee that
an application circuit designed around the module is USB compliant. The choice of
application circuit, component choice and PCB layout all affect USB signal quality and
electrical characteristics. The information in this document is intended as a guide and
should be read in association with the USB specification, with particular attention being
given to Chapter 7. Independent USB qualification must be sought before an application is
deemed USB compliant and can bear the USB logo. Such qualification can be obtained
from a USB plug fest or from an independent USB test house.
Terminals USB_D+ and USB_D- adhere to the USB specification 2.0 (Chapter 7) electrical
requirements.
6.2.8 USB 2.0 Compatibility
WT32 is compatible with USB v2.0 host controllers; under these circumstances the two
ends agree the mutually acceptable rate of 12Mbits/s according to the USB v2.0
specification.