Installation Guide

- 5 -
OPERATION
A
C
B
D R
Button A = turns the lights on/low/high/o .
Button B = Activates/Deactivates the delay-o feature. Press once (when blower is on)
to activate the delay-o feature. The selected speed level that is displayed in display “C”
will blink when this feature is activated. After 10 minutes, the blower will then turn o .
Delay can be deactivated at any time by pressing the button again.
Display C = Indicates the selected speed of the blower 1, 2, 3, or b for boost.
“-” indicates the need to clean the grease lter.
Button D = Turns on the blower. Hood will turn on to the last speed selected. The blower
speed will change each time the button is pushed (from 1 to “b”). To turn the blower o ,
press and hold button for approximately 2 seconds.
Button R = Filter clean indicator reset. Press and hold for 2 seconds to reset the indicator.
HEAT SENTRY
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that
will turn on or speed up the blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF.
When this occurs, it is impossible to turn the blower OFF with its switch. If you
must stop the blower, do it from the main electrical panel.
Controls (Fig.1)
HALOGEN BULBS
This range hood requires 3 or 4 halogen bulbs
(based on size of hood)
(Type T4, 120 Volt, 25 Watt Max, G9 Base).
WARNING: Always switch o the electrical
supply before carrying out any operation on
the appliance.
To change bulbs:
1. Open the cover by gently prying from proper
slots (Fig.2).
2. Remove the bulb by pulling sideways
(DO NOT ROTATE). CAUTION: Bulb may be hot.
3. Replace with Type T4, 120 Volt, 25 Watt Max,
G9 Base halogen bulbs. Do not touch replacement bulbs with bare hands!
!
FIG. 2