Installation Instructions

- 8 -
WATERPROOF WIRE CONNECTORS INSTRUCTIONS:
1. Strip wires 3/8’’.
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires together with ends even, but lead smaller stranded wires slightly ahead of larger solid
or stranded wire.
4. Twist connector onto wires pushing firmly until hand-tight. DO NOT over torque.
5. When inserting wires into connectors, some sealant may leak out. Wipe off excess sealant in and around conductors. DO
NOT REUSE.
Refer to the instructions included with the selected blower/rough-in kit
(sold separately) for details on installing the rough-in plate. Install the
rough-in plate so that the wiring box is located on the right side as you
are facing the hood.
Attach 10” round duct to rough-in plate.
8. INSTALL ROUGH-IN PLATE
HD0480
LOCKNUTS
9. CONNECT WIRING
WARNING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all
applicable codes and standards. Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power to be switched on accidentally.
!
Remove wiring cover from rough-in plate and set aside.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw.
Reinstall wiring cover.
10. INSTALL BLOWER
Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle and the power supply cord (B) onto the male
connector inside the hood.
HE0078
A
B
Do not plug the two cords into each other.
WARNING
!
CAUTION
Install rough-in plate using 4 x 10-32 locknuts and washers
included in hood parts bag. Discard nuts provided with
rough-in plate.