Installation Instructions

- 10 -
Grease Drip Rail
The grease drip rail should be cleaned frequently. Wash with clean cloth soaked in warm detergent solution. Wash more often
if your cooking style generates greater grease like frying foods or wok cooking.
Blower(s) Cleaning
Access the blower(s) and use vacuum to clean. Do not immerse in water.
14. CARE (CONT’D)
Hood Cleaning
Stainless steel cleaning:
Avoid when choosing a detergent:
• Any cleaners that contain bleach will attack stainless steel.
• Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
• Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should
never be used close to a range.
Do:
• Regularly wash with clean cloth or rag soaked with warm
water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Use any steel or stainless steel wool or any other scrapers
to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach
the hood. During construction/renovation, cover the hood
to make sure no dust sticks to stainless steel surface.
BLOWER
The blower is operated using two controls.
Use the on/off rocker switch (1) to start and stop the blower. When
turned ON, the switch turns red and the blower operates at the speed
set by the speed control knob (2).
Turn the speed control knob clockwise to increase blower speed –
counterclockwise to decrease speed.
COOKTOP LIGHTING (HALOGEN)
Use the on/off rocker switch (3) to turn the halogen lights ON or OFF.
1) ON/OFF BLOWER SWITCH
2) B LOWER SPEED CONTROL KNOB
3) H ALOGEN LIGHT SWITCH
HC0060
2
3
1
15. OPERATION
HEAT SENTRY™
This hood is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will turn on the blower to high speed if
it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to high speed.
2) If blower is already ON it sets blower on high speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY can start the blower during a range
top fire or other excessive heat situations even if the hood
is turned off. In this case, it is impossible to turn the blower
OFF using control panel switch. To stop the blower,
disconnect blower plug (A).
!
HE0078
A