Installation Guide

- 9 -
INSTALL THE HOOD
Remove the plastic protective film from all
exterior surfaces, decorative flues and
filters, prior to final installation.
1. Construct wood wall framing that is flush
with interior surface of wall studs (Fig. 6).
Make sure:
a) the framing is centered over installation
location.
b) the height of the framing will allow the hood
to be secured to the framing within the
dimensions shown.
2. Install the (2) 6 x 60mm screws for the top of
the hood at the dimensions shown in Fig.7-8.
Use the two outer keyhole slots, do not
completely tighten the screws.
3. Hang the hood onto the screws.
4. Secure (2) 6 x 60mm screws at the outer
locations of the hood. Tighten all (4) screws.
Notes:
a. Minimum hood distance above cook top
must not be less than 24”. A maximum of
36” above cook top is highly
recommended for best capture of
cooking impurities. Distances over 36”
are at the installer and the users
discretion; and if ceiling height and flue
lenght permit.
FIG. 6
FRAMING BEHIND WOOD
CROSS SUPPORT
WOOD CROSS
SUPPORT BEHIND
DRYWALL
DRYWALL
MOUNTING
SCREWS
3,9x9,5mm
FIG.5
MOUNT ELECTRICAL PLATE
Fix the elctrical plate with 4 screws
(3.9x9.5mm) to the hood, the screws are
located in the Hardware Package (Fig. 5).