User manual

- 9 -
FIG. 6
FRAMING BEHIND WOOD
CROSS SUPPORT
WOOD CROSS
SUPPORT BEHIND
DRYWALL
DRYWALL
MOUNTING
SCREWS
3,9x9,5mm
FIG.5
MOUNT ELECTRICAL PLATE
Fix the elctrical plate with 4 screws
(3.9x9.5mm) to the hood, the screws are
located in the Hardware Package (Fig. 5).
INSTALL THE HOOD
Remove the plastic protective film from all
exterior surfaces, decorative flues and
filters, prior to final installation.
1. Construct wood wall framing that is flush
with interior surface of wall studs (Fig. 6).
Make sure:
a) the framing is centered over installation
location.
b) the height and width of the framing will
allow the hood to be secured to the framing
within the dimensions shown in Fig.8.
2. Install the (2) 6 x 60mm screws for the top of
the hood at the locations shown in Fig.7.
Use the two upper keyhole slots, do not
completely tighten the screws.
3. Hang the hood onto the screws.
4. Secure (2) 6 x 60mm screws at the lower
locations of the hood. Tighten all (4) screws.
Notes:
a. Minimum hood distance above cook top
must not be less than 24”. A maximum of
36” above cook top is highly
recommended for best capture of
cooking impurities. Distances over 36”
are at the installer and the users
discretion; and if ceiling height and flue
lenght permit.
Mounting Hole Height Above 36” High Cook Top (inches)
Ceiling
Height
(Feet)
Duct
Method
37-5/8
8
Ducted
9
Ducted
38
36
48 47
46
44
43 42
41 40
39
45
26
25
37
36 35
34
32
31 30
29
28
27
33
Hood Distance Above 36” High Cook Top (inches)
38-5/8
39-5/8
40-5/8
41-5/8
42-5/8 43-5/8
44-5/8
45-5/8
46-5/8 47-5/8
48-5/8
49-5/8
24
33
35
24
25
27
28 29
30
31
32
26
34
36