Instructions

- 9 -
INSTALL FLUE MOUNTING
BRACKET
DUCTED AND NON-DUCTED HOODS
1. Assemble the flue mounting bracket,
adjusting outside width as shown.
Fig. 7.
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the
ceiling using (2) 4.8 x 38 mm mount-
ing screws and drywall anchors.
Fig. 8. Make sure the bracket is pushed
into the corner, tight against the wall
and centered over the hood.
FLUE MOUNTING BRACKET
7-11/16”
FIG. 7
3.9 x 6 mm FLAT HEAD
BRACKET SCREWS
FIG. 8
4.8x38mm
MOUNTING SCREWS
DRYWALL ANCHORS
DRYWALL
ANCHORS
FIG. 11
INSTALL THE HOOD
Note: Remove the plastic protective
film from all exterior surfaces, deco-
rative flues and filters, prior to final
installation.
DUCTED and NON-DUCTED
INSTALLATION
1. Install hood onto the wall mounting
bracket. Make sure hood is level with
floor. Fig. 9.
2. Make sure hood is level with floor. Use
adjustment screws to level. Fig 10.
3. Mark and install (2) additional drywall
anchors and screws as shown. Fig. 11.
4. Secure hood to wall with (2) 4.8 x 38
mm mounting screws and (2) drywall
anchors. Figs. 10 & 11.
FIG. 10
4.8 x 38 mm
SCREWS
FIG. 9
4.8 x 38 mm
SCREWS