Installation Guide

- 9 -
INSTALL THE HOOD
NOTE: At least three people will be re-
quired to mount the hood.
1. Raise the hood up into the wall cabi-
net. Adjust brackets to contact inside
walls of the cabinet.
2. Make sure the front edge of the hood
drawer support is aligned with the front
of the wall cabinet. Center the hood
on the wall cabinet.
3. Tighten the (4) mounting bracket ma-
chine screws previously installed.
4. Fasten the hood to the cabinet with
(8) 4.8 x 12mm pan head screws.
Make sure that screws will not pen-
etrate finished cabinet side walls.
5. Open the slide out drawer. Place the
glass panel into the open recessed
area of the drawer.
6. Slide glass left or right until it is cen-
tered in the opening and securely re-
tained.
MOUNTING
BRACKET
DRAWER
GLASS
FRONT
EDGE OF
CABINET
DRAWER
CENTERED
FRONT EDGE
OF DRAWER
SUPPORT
SCREWS
(4.8 x 12mm)