Installation Guide

- 5 -
HALOGEN BULBS
This range hood requires two halogen
bulbs (Type JC, 12V, 20Watt max, G4 Base).
WARNING: Always switch off the
electrical supply before carrying out any
operation on the appliance.
To change bulbs:
1. Open the cover by prying from the proper
slots. DO NOT ROTATE.
!
CAUTION: Bulb may be hot.
2. Replace with a JC, 12V, 20 Watt max, G-
4 Base bulb. Do not touch replacement
bulb with bare hands!
DO NOT use bulbs greater than 20
Watts. Bulbs greater than 20 Watts will
cause the fuse to open.
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCON-
NECT POWER AT THE SERVICE EN-
TRANCE. CHECK THE FUSE AND RE-
PLACE IF NECESSARY.
1. Remove the grease filter and pull the
visor open.
2. Locate the fuse holder on the top right
hand side of the light housing.
3. Unscrew the fuse holder cap and re-
move the fuse.
4. Replace the fuse with the same size and
amperage (5 x 20mm, 4 amp, 125 volt).
DO NOT use fuses greater than 4
Amps. Fuses greater than 4 Amps may
damage the transformer.
5. Reinstall the fuse cap and grease filter.
6. Reconnect power at the service en-
trance.