P195P Installation Guide 99045018C

- 6 -

 

    
       
INSTALL THE HOOD
1. Cut a hole in the bottom of the cabinet.
See Fig.5
2. To install the hood, adjust the position of
the clasping side spring by turning the
screws, according to the thickness of the
cabinet to which it is going to be anchored.
See Fig.6
3. Insert the hood in the cabinet and lock into
position using the side spring.
4. Use the holes in the hood, secure it with (4)
mounting screws (B) - 3.2 x 16mm. See Fig.7
A= min 7/16- max 13/16
CONNECT DUCTWORK
1. Use 6"or 8 round metal duct to connect
the duct connector on the hood to the
ductwork above.
2. Use duct tape to make all joints secure and
air tight.
CLASPING SIDE
SPRING
A
MOUNTING SCREWS
(3.2x16mm)
Fig.5
Fig.6
Fig.7
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical codes.
 120 VAC INPUT (FIG.8)
1. Secure the conduit to the wiring box through
a conduit connector.
2. Make electrical connections. Connect white
to white, black to black and green to green.
3. Install wiring box cover and secure it with (2)
screws 3,9 x 6 mm and (2) washers. Make sure
that wires are not pinched between cover
and box.
 MAKE-UP AIR DAMPER CONNECTION (FIG.9)
1. Secure the conduit to the wiring box through
a conduit connector.
2. Make electrical connections. Connect black
to orange and black to white
Refer to Air Damper Models MD6T/MD8T
instruction.
3. Install wiring box cover and secure it with (2)
screws 3,9 x 6mm. and (2) washers. Make
sure that wires are not pinched between
cover and box.
WIRING
BOX
COVER
(2) SCREWS
(3,9 x 6mm)
WIRING
BOX
COVER
WASHER
WASHER
(2) SCREWS
(3,9 x 6mm)
MAKE-UP AIR
DAMPER
CONNECTION
120 VAC INPUT
Fig.8
Fig.9
2 Mounting screws on
each side (as shown)
Dimension from bottom
edge of cabinet to center
line of screw/hole
0,3- 0,4
B