Installation Guide

- 11 -
INSTALL THE HOOD
DUCTED AND NON-DUCTED INSTALLA-
TION
1. Remove the electrical system box from
chimney frame by removing (2) 3.9 x 9.5
mm screws (Fig. 8).
2. Attach electrical system box to frame using
(2) 3.9 x 9.5 mm screws removed in Step 1
and (2) 3.9 x 9.5 mm screws and (2) lock
washers from hardware bag (Fig.9)
3. Fix the damper kit onto the hood using 4
screws (3.9x9.5mm) located in the Damper
Package (Fig.10).
4. Adjust the overall height using the chart
shown on page 10 of the support frame.
Loosen and re-tighten the 4 screws in the
height adjustment slots as necessary.
Insert 12 screws (3.9x9.5mm) located in
the Hardware Package (Fig.11) make sure
this a 4” min. overlap between the upper
and lower support legs.
SUPPORT
FRAME
MOUNTING
SCREWS
(6x60mm)
HEIGHT ADJUSTMENT
SLOTS
FIG.11
MOUNTING
SCREWS
3,9x9,5mm
FIG.9
FIG.8
FIG.10
MOUNTING SCREWS
3,9x9,5mm
MOUNTING SCREWS 3,9x9,5mm
MOUNTING SCREWS 3,9x9,5mm
MOUNTING SCREWS 3,9x9,5mm
WASHERS