Installation guide

- 5 -
4. MOUNT CUSTOM HOOD INTERNAL FRAMEWORK
5. REMOVE FILTERS
HD0295
Since the CP34, CP35 and CP37 power pack models mounting holes are
located in front and rear sides (see illustration beside), plan to install wood frame
at front and sides for support.
HH0102A
The CP34, CP35 and CP37 power pack models are supported by the custom hood internal framework with screws provided in
parts bag.
WARNING
The framework must be positively secured to wall studs or other wooden framework behind the drywall.
Make sure it is capable of supporting its own weight and the weight of the CP34, CP35 or CP37. Failure to
do so may cause personal injury or damage to countertop or cooktop.
!
Remove tape on filters. Remove filters from power pack and set aside.
NOTE: It is recommended to start with the center one(s).
To minimize the gap around the power pack, take actual width and depth
measurements of power pack and add 1/16” to get D and E measurements. Cut
the hole in the bottom of the cabinet according to dimensions. See chart and
illustration for details.
E
HD0367
D
3. CUSTOM HOOD PREPARATION (CONTINUED)
POWER PACK
MODELS
WIDTH
CUTOUT DIMENSIONS
D E
CP34 & CP35
30” 19
3
⁄8” 28½”
36” 19
3
⁄8” 34½”
42” 19
3
⁄8” 40½”
CP37 48” 22
5
⁄8” 46½”