Installation Guide

- 14 -
• Rotate blower 90 degrees and reinstall (2)
screws (Fig.17). Reinstall blower box cov-
ers, damper and screws.
2. Adjust height of the telescoping support
frame and secure with screws and washers.
Fig.18.
CAUTION: Adjust the height before
installation.
3. Lift range hood into the ceiling opening.
4. Secure each support frame to the wooden
hood support frame using (6) 6 x 60 mm
lag bolts and washers provided. Fig. 19.
5. Install exterior or in-line blower by
following instructions provided with
blower.
6. Install ductwork and duct tape all joints to
ensure an air tight seal.
2x4 WOOD
FRAME
(6) WASHERS
& LAG BOLTS
FIG.19
FIG.17
FIG.18