Installation Guide
- 6 -
OPERATION
(P1) Delay- Off Switch
• Your hood includes a 10 minute blower delay o switch. Press this switch once to activate
the timer and the LED Ring (L1) ashes blue. The blower will continue to operate for
10minutes. After 10 minutes, the blower turns o automatically.
• To cancel the 10-minute delay, press the delay switch once again.
(P2) Filter Alarm Switch
• After 30 hours of blower operation, the lter alarm is activated and the LED ring (L1) turns
red/ ashes. It indicates that the grease lters need to be cleaned.
• After cleaning the grease lters, reset the hour counter by pressing the Filter Alarm/Timer
Reset button (P2) during display of the alarm.
(P3) Blower Speed Decrease and Off Switch
• Press to decrease blower speed, high to low. The LED ring (L1) ashes blue at a speed
proportionate to the blower setting (i.e.: four ashes is high speed, one ash is low
speed, etc.)
• Continue pressing this switch to turn the blower o .
(P4) Blower Speed Increase and On Switch
• Press this switch to turn the blower on to low speed.
• Press again to increase blower speed, low to high. The LED ring (L1) ashes blue at a
speed proportionate to the blower setting (i.e.: four ashes is high speed, one ash is low
speed, etc.)
(P5) Light Switch
Lights o /low/medium/high.
Controls (Fig.2)
The hood is operated using the (5) push buttons located on the hood and the remote control.
LED colors are displyed on hood control only.
FIG. 2
P1: Activate/deactivate delay-o (10 minute)
P2: Filter change indication timer reset
P3: Decreases fan motor speed until turned o (4>3>2>1>OFF)
P4: Turns fan motor on and increased speed (ON>1>2>3>4)
P5: Lights o /low/medium/high
L1: LED Indicator Ring Signalling crown:
- Hood in standby: lights up green. 30 seconds after
the last key has been pressed the crown turns o
- Motor on: L1 lights up blue fl ashing. The fl ashing
frequency is proportional to the speed setting.
- 10’ TIMER function : L1 lights up and ashes blue.
- Filter alarm active: L1 lights up red
L1
LED
RING