User manual

- 14 -
SERVICE PARTS
KEY NO. DESCRIPTION PART NO.
CAS BLOWER ASSEMBLY B06002259
506 BLDC DRIVER 97019431
67 WIRES B06102601
202 WIRE CLAMP B03292290
415 BUSHING B03202288
IME ELECTRICAL INSTALLATION ASSEMBLY B06142982
67 WIRES B06102598
115 FEEDER CABLE CONNECTION BOX BE3350233
415 BUSHING B03292596
116 FEEDER CABLE CONNECTION BOX COVER BE3334252
125 UPPER TELESCOPIC SKELETON B08092797
124 BOTTOM TELESCOPIC SKELETON BE3350919
64 BOTTOM BRACKET B08093079
507 CALIBRATION BUTTON ASSEMBLY B06102584
439 GROMMET B02320034
474 LED LIGHT B08089101
250 RING NUT B02011389
AQI SWITCH BOX ASSEMBLY B06102975
343 CLOSURE PANEL B08093078
477 HINGE B02011376
362 DOOR MAGNETS WITH SCREWS B080811027
9 GREASE FILTER B08087804
ARU CONNECTION AIR OUTLET SET B08092501
ACR3 REMOTE CONTROL B08999186
998 HARDWARE B080810994
999 INSTALLATION INSTRUCTIONS B080813923
Model CC34IQSB
Three options are available if your hood
system has too much restriction:
1. Accept airflow as is.
a. Press the calibration button to
accept airflow as is. The IQ Blower
System™ is now configured to the
highest possible performance. The
blinking calibration light goes out.
Note: The LED will also turn off if
you select any blower speed on
the control.
2. Correct duct restriction, clear the
original calibration data, and repeat
the calibration process.
a. Correct the duct restriction.
b. Clear the original calibration data
by holding calibration button for
10 seconds. The light will blink 3
times to confirm and the blower
configuration will go back to default
settings.
c. Repeat calibration process from
the beginning.
3. Clear calibration data to reset hood
to default factory setting and achieve
standard high pressure blower
performance.
a. Clear calibration data and reset
hood to factory default setting
by holding calibration button for
10 seconds. The light will blink 3
times to confirm and the blower
configuration will go back to default
settings.