Manual

- 15 -
INSTALL THE FILTERS
1. To install the grease  lters, align rear  lter tabs
with slots in the hood. Push latch tab in, push
 lter into position and release. Make sure  lter
is securely engaged after installation. Fig. 16.
2. To remove the  lters for cleaning, push latch
tab in to disengage  lter from hood. Tilt the
 lter downward and remove.
NOTE: Remove protective  lm from  lters and
steel surfaces before using cooking under
range hood.
FIG. 16
PROGRAMMING MODE
PROCEDURE
The range hood is designed to work with
several di erent blower models. Before
us-ing, the control must  rst be programmed
to your blower model, in order to achieve
proper operating speeds.
From the chart below:
1. Find the SETUP number that corresponds
to the blower model that is installed with
your range hood.
2. The control is factory-preset to SETUP 3.
If your blower model is listed under SETUP
3, no programming is required. The range
hood is ready to use.
3. For blower models listed under SETUP 1
or 2 follow this program sequence:
A - Power at the service box must be
ON while programming. The blower and
lights must be turned o .
B - Press P2 for 3 seconds. The L1
LED ring will  ash at 3 di erent rates of
speed: slow  ashing speed = SETUP
1; medium  ashing speed = SETUP 2;
fastest  ashing speed = SETUP 3 (the
factory-preset default).
C - To select the proper SETUP, press
P3 (-) or P4 (+) to change to SETUP 1,
2 or 3.
D - Once the proper SETUP is found,
press P2 (f) to memorize the SETUP
setting.
E - The range hood is now ready to use.
EB6 EB12 EB9
ILB3 EB15 ILB11
ILB6 ILB9
SETUP 1
SETUP 2 SETUP 3(default)
BLOWER
MODEL
NUMBER